Duratrax Raze Instruction Manual

ASSEMBLY AND OPERATION MANUALwww.duratrax.com®™

10MAINTENANCETIPSBEFORE EACH RUN1. IMPORTANT: Check to make sure that all screws are tight. Always use threadlock (DTXR2010) on screws going into met

11TOE-IN AND TOE-OUTToe-in is when the fronts of the tires point towards each other. Toe-in increases stability during acceleration and high speed. Ho

12Use threadlock on all metal-to-metal screws.The following section is provided to help you with maintenance and repairs to your Raze ST. Pay extra at

13Use threadlock on all metal-to-metal screws.Make sure all bearings are fully seated.Fill the diff case with quality oil or grease. NOTE: Fill the ca

14Use threadlock on all metal-to-metal screws.Make sure all bearings are fully seated.Thread the ball ends onto the turnbuckles equally. Adjust after

15Use threadlock on all metal-to-metal screws.Make sure all bearings are fully seated.Use threadlock on all metal-to-metal screws.Make sure all bearin

16Make sure all bearings are fully seated.Thread the turnbuckle into the rod ends equally. Adjust after assembly is complete.

17Completely fi ll the shock body with shock oil. Slowly work the piston up and down to remove air bubbles. Slowly tighten the shock cap onto the shock

18Make sure the hex portions of the braces and wing mount are properly aligned before tightening.Use CA glue to secure the tire to the wheel.

19Use threadlock on all metal-to-metal screws.Use threadlock on all metal-to-metal screws.

2ITEMSINCLUDEDYOU WILLNEED20% O’DONNELL FUELODOP3320AFTER RUN OILHCAP3000WRENCHDTXR1170SPARE GLOW PLUGSDTXG3005AIR FILTER OILDTXC2465ALKALINE BATTIERS

ENGINETROUBLESHOOTINGThe Engine StartsDoes it runcontinuously?It should beready to go.Is the highspeed needlesetting 3-1/2 to3-3/4 turns outfrom close

3THINGS TOKNOWSAFETY PRECAUTIONSWhen the safety precautions are followed, the Raze ST will provide years of enjoyment. Use care and good sense at all

44FINISHINGTHE RAZE STTRANSMITTER PREPARATION• Install eight “AA” batteries into transmitter, making sure the polarity is correct.• Insert the antenn

55RECEIVER ANTENNA INSTALLATIONANTENNAWIREFUELTUBINGANTENNA TUBEANTENNA MOUNTANTENNACAPDO NOT CUT THEANTENNA WIRE!X• Install the small piece of fuel

666RADIO SYSTEM CHECKSTEERINGDUAL RATETRANSMITTERANTENNASTEERINGTRIMTHROTTLETRIMTHROTTLEBRAKEON/OFFSERVOREVERSINGPOWER LED1. Fully extend the transmit

7ENGINETUNING GUIDEHIGH-SPEED NEEDLE The “high-speed” needle is sticking up from the carburetor. This controls the fuel to air mixture of the carburet

8BREAK INPROCEDURESOME THINGS TO REMEMBER DURING BREAK-IN1. Run with the body off. This will keep the engine cooler.2. Keep the air cleaner on at ALL

9GENERALINFORMATIONGLOW PLUGThe glow plug is an item that will wear out and need replacement from time to time. It is a good idea to remove the glow p